The Eliminator Pro is manufactured from 6061 T6 Aircraft Aluminum with solid steel pins, giving the entire system a weight a little over 7oz. This unit will fit any bow on the market!*
The Eliminator Pro has four set up options. It is offered with 3 different Vertical Pins, and now with a Horizontal Pin set up. The Vertical Pins are all preset. The 5-Dot pin has an 1/8" gap between the fiber optic dots. This pin is made for faster shooting bows (bows with an arrow speed of 260 or faster). The general concept behind this is, if you sight-in your bottom pin at 60 yards you will have approximately 10 yards between your other pins. The 3-Dot and 4-Dot pins have a 1/4" gap between them. These are for slower shooting bows (bows with an arrow speed of 250 or slower). The Horizontal Pin comes with a 3-Pin set up, however, you can order additional pins if needed. With this set up you can position your pins at what ever yardage you prefer.
The rear part of the sight is the first area you set up. This attaches to your anchor point, ensuring comfort when you look through at full draw. The next step is to bring your front sight over until it lines up with the rear pin. Thats it!
You can obtain instructions by downloading them here. An instructional DVD is included inside the package as well.
*If using the PSE X Force with a 6" brace height, The Eliminator Pro will work on your bow, but you have to flip the rear pin tail section over. Turn the straight edge side toward the back of your riser, the 45 toward your cables, and make sure you use a cable stop on your cable slide bar.